admin> switchshow
Note:Any devices that connect using NPIV use nsshow command to find the WWPN addresses logged in to the port.If you cannot find the WWPN listing, you have to identify the WWPN manually from server / HBA and run “nodefindWWPN “ to verify that the WWPN is available on switch for zoning.
2.Run the cfgshowcommand
admin> cfgshow
cfgshow will display the configuration and how the zoning is currently configured. This will display two sections, Defined Configuration and Effective Configuration.
3.Run the alicreate command to create aliases for the HBA addresses that you identified by either running switchshow command or manually.
admin> alicreate “ALIAS_NAME”, “WWPN”
Note :You can do this for both the Initiators and Target addresses
4.Run the zonecreate command to create the zone.
admin> zonecreate “ZONE_NAME”, “ALIAS_NAME_OF_INITIATOR”
Note :- You may use multiple alias’s or single alias while creating zone , multiple alias’s can be added by “ALIAS1;ALIAS2” , Also note that there should not be any space after zone name .
5.Run the zoneadd command to add the aliases of the Target ports to the zone that was created.
admin> zoneadd “ZONE_NAME”, “ALIAS_OF_TARGET(S)”
6.Once zone is created, add it to an active configuration or a new configuration by running either the cfgadd command or cfgcreate
Add to an existing configuration
admin> cfgadd “CONFIG_NAME”,”ZONE_NAME”
Add the newly create zone to the configuration
admin> cfgcreate “NEW_CFG_NAME”,”ZONE_NAME”
7.Next you have to save the configuration by running the cfgsave And it will prompt for yes / no you have to hit yes at the prompt to save the configuration and this does not put the configuration into production
admin> cfgsave
8.To activate the created zoning, run the cfgenable And it will prompt for yes / no, you have to hit yes at the prompt to activate the configuration
admin> cfgenable CONFIG_NAME
Note: This will put the zone into the Effective Configuration and will be live in production.
Check More useful Commands on POST
